NC Cardinal Support and Staff Education
  • Home
  • Submit a Request
  • Check on a Request
  • Knowledge Books
    • About NC Cardinal
    • Acquisitions in Evergreen
    • Administration Manual for Libraries
    • Cataloging in NC Cardinal
    • Circulation in Evergreen
    • Evergreen Upgrades
    • Libraries Migrating into NC Cardinal
    • Serials in Evergreen
    • Offline Transactions
    • Reports in Evergreen
    • Resource Sharing
    • Student Access Initiative
    • Summon Documentation
    • Troubleshooting in Evergreen
Powered by HelpSpot

Home → Administration Manual for Libraries → Client & Workstation Setup and Administration → Setting Up a Label Printer

2.6. Setting Up a Label Printer


This example is for a Dymo Labelwriter 450 Turbo

Go to the Dymo website and find the software download that matches the printer model you have. Download and install that software.

Go into Evergreen and under Administration > Workstation Administration find the Printer Settings Editor. I believe you have to go to the label printer settings, go into the settings for the margins, and change everything to zero margins and blank for all the header and footer stuff.

I've attached the spine label settings that I use. I took it when I didn't have a large screen so you can't see the bottom three settings in the screenshot but I leave those three blank so it doesn't matter. You can tweak them from here to whatever you like after you make sure it prints correctly.


This page was: Helpful | Not Helpful